Replacing The Pulleys; Motor Connection - lavina 32-S-E User Manual

Superabrasive
Figure 9.5.4 Figure 9.5.4
Figure 9.6

9.7 MOTOR CONNECTION

In case of changing the motor, please check the cable connection to your motor.
®
Lavina 32-S-E
The motor is connected in "Star" 380 Volt, reminder
for the wire connection of the motor.
Owner's Manual Original Language – Lavina

9.6 REPLACING THE PULLEYS

Take the belt tension away (see the previous paragraph). After removing
the belts, unscrew the four bolts of the pulleys on top of the disc (Fig. 8.12
1)..
®
32-S-E
To change the tension, turn loose the bolt (Fig. 9.5.4 11) on
top of the puller, LOOSE THE 5 BOLTS in the middle (fig.
Fig. 9.5.4 8) loose also on the half moons the bolts ( Fig.
9.5.4-8.1 and Fig. Fig. 9.5.4-9).
Turn loose the secure nut on both forks (Fig. Fig. 9.5.4 7),
begin to tension with inner nut work similar on both belts
(Fig. 9.5.3).
After matching the right tension secure all previous bolts.
When replacing the belts, take off the tool holder and
remove the bottom cover. Un-tension completely. Replace
the belts, put them on the right place in the grooves. Use
(Fig. 9.5.4) and pull them at last over the tension rollers
(Fig. 9.5.4-4, 9.5.4-5). Tension as earlier described.
SQUEALING NOISE If a squeling noise of the belt is heard,
it means the belt is not pendicular with the pulleys. By
tension the belt avoid to loose the botls too much so the
pulleys are staying in an exact vertical position.
Figure 9.7
18
6/2013