Table of Contents
Advertisement
If there is no CD inserted or the CD is not in playback mode, you can switch between the different
digital inputs by pressing the STATION buttons of the RC 3. P Press PLAY to return to CD mode.
If a variable output level has been activated in the personal setup menu (see 3.1.1), you can control the
output level of the analogue outputs of your CD 3.2 / CD 5.2 by pressing the VOLUME buttons on your
RC 33 remote control (see also 2.3).
1.7.1 Battery change
Bottom view RC 3 remote control
Unscrew the 6 marked screws (CAUTION: Do NOT unscrew the 2 unmarked screws in the middle).
Take the bottom plate with the mounted pcb out. Remove the worn batteries and replace them with
two new batteries (type CR2032, 3V Lithium cells). Make sure that polarity is correct (the "+" sign must
be on top). Insert the bottom plate and screw it tight.
1.7.2 External IR remote control
The CD 3.2 / 5.2 can be connected to an external IR receiver by using the IR jack (25). The plug is a
3,5mm stereo headphone plug.
Pin configuration of IR connectors (25)
3,5mm stereo
infrared input
GND
IR-Signal
+5V supply
6
Advertisement
Table of Contents
