Appliance Elements; Preparing The Vacuum Cleaner For; Operation And Usage - Fakir HYGIEN 2600 H2O Instruction Manual

Appliance Elements

1 ON/OFF button
2 Handle
3 Plug and cord
4 Cord rewind button
5 Power adjustment button , (type 829.0)
6 Power level indicator (type 829.0)
7 Accessory compartment cover
8 Motor filter (installed in the vacuum cleaner)
9 Foam filter II (installed in the vacuum cleaner)
10 H.E.P.A. outlet filter (installed in the vacuum cleaner)
11 Foam filter III (installed in the vacuum cleaner)
12 Anti-foam agent
13 Foam fi lter I (installed in the vacuum cleaner)
14 Suction hose
15 Telescopic suction tube
16 Crevice nozzle
17 Small brush
18 Small nozzle
19 Water pick up nozzle
20 Parquet brush
21 Brush with a small item separator
22 Water fi lter module (fi ltration unit + partition)
Preparing the vacuum cleaner for operation
1. Press the "PRESS" button and remove the tank lid.
2. Insert the partition to the grooves in the container
so that the shutters are directed downwards. Make
sure the partition is correctly mounted in the container
i.e. the partition fins should cover the protrusion in the
container.
3. Fill the container with 1,2 liter of water. The water
level should be in the range marked on the tank wall.
ATTENTION! Do not operate the appliance with
an empty container while vacuum cleaning with
the use of the water fi lter module.
4 Insert the filtration unit to the tank, make sure that
the two air stub pipes are in the openings of the
vacuum cleaner body.
1 6
A 5. Insert and snap the tank lid shut.
6. Insert the end of the suction hose to the vacuum
cleaner opening so that the hose interlock is in the
protrusion of the opening. A characteristic click
indicates that the hose has been properly installed.
7. Connect the other end of the hose (handle) with the
telescopic suction tube.
8. Adjust the length of the telescopic suction tube by
sliding the slider according to the arrow and pull
out/pull the tube together.
9. Assemble the appropriate nozzle or brush to the
other end of the suction tube.
10. You may assemble a basket for picking up small
objects in the brush with a small item separator. In
order to do so remove the basket cover and insert the
basket.
11. To clean hard surfaces – wooden fl oors, plastic fl
oors, ceramic tiles etc. pull out the brush by pressing
the switch on the nozzle according to the fi gure .
12. The vacuum cleaner is equipped with an accessory
compartment. The compartment is located in the front
lid of the appliance. To open/close the compartment
lift/close the lid and take out/ put away the desired
nozzle.
13. Grab the plug (3) and pull the cord out of the
vacuum cleaner.
ATTENTION! While pulling out the cord pay
attention to the yellow stripe which signals the
end of the cord. Further attempts (pulling on cord)
may result in damaging the cord.
14. Plug in the appliance.
B
ATTENTION! Before operation, make sure that all
fi lters as well as the appropriate module are
installed in the appliance.
15. Switch on the vacuum cleaner by pressing the
"on/off" button (1).
16. Set the desired power value by pressing the power
adjustment buttons
ATTENTION! It is strictly prohibited to vacuum
without the dust bag and the inlet fi lter or with a
damaged dust bag. It may cause a failure of the
vacuum cleaner motor.
, (5).