Cleaning And Maintenance Of The Appliance - Fakir INOVAX User Manual

EN
Insert one of the accessories (flexible joint G4, upholstery nozzle G3, crevice nozzle G2) into
charging stand H.

Cleaning and Maintenance of the Appliance

Before any maintenance, disconnect the charging adapter from the appliance. Clean the
vacuum cleaner surface and the charging adapter with a soft damp cloth; do not use abrasive
and aggressive cleaning agents! Never dry plastic moldings over a heat source (e.g. heater,
electric/gas stove). Check and clean the vacuum channel of floor nozzle brush and the main
stick body (above the reservoir) occasionally. Remove the blockage and take out any waste.
Floor nozzle F, rotary small turbobrush G1
Wipe the floor nozzle with a damp cloth. After every vacuuming, check if any dirt is trapped
in the rotating brush. If the brush is unclean, please remove it from the floor nozzle according
to Fig. 9, 10. Now you may easily clean the brush (rinse it in running water).After wash the
roller brush, please dry the shaft at end of brush (milky plastic location) with damp cloth to
avoid rusting. Warning: Do not water the floor nozzle in running water directly, it will damage
motor and PCB. After the maintenance, apply a reverse procedure to install the brush in the
nozzle and secure it.
Release the two arrest latches F3 on the bottom side of the nozzle in the direction of the arrow
and remove the cover (Fig. 11). Release the holder F4, then take out the hose from groove
to clean it. Clean the space with a suitable tool (e.g. tweezers). After cleaning, reassemble it.
Accessories (G)
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
Other parts (C, E)
extension adapter/suction tube C and extension adapter E with a wet cloth. Allow all the
parts to dry out properly before re-use.
HEPA filter, separator and seal ring
Remove separator B2 and seal ring B3 from the HEPA filter (Fig. 8). Rinse the separator and
seal ring in running water. Clean the HEPA filter by knocking or blowing (for sanitary reasons,
we recommend doing this outside residential premises). If the HEPA filter is very dirty, you
can rinse it under running lukewarm water (i.e. tilt the HEPA filter to the side while holding it
so that the "dirty" fanfolded side is pointing upwards, water can flow along the
folds and wash out the dust stuck in between the folds). Turn the HEPA filter by 180° and
allow water to flow over the folds in the opposite direction. Keep turning and washing the
HEPA until it is clean. Allow it to dry out properly. After the maintenance, put the HEPA filter
and the separator back in the dust container B.
41