Table of Contents
Advertisement
CONTROLS IN DETAIL, CONTINUED
41.
QUICK CONTROL DIAL ACCESS KNOB: Rotates clockwise and counterclockwise. It can be used alone or
in combination with other controls to select or set various camera functions or modes. Refer to camera manual
for in depth use.
42.
ATTACHEMENT SCREW HOLES FOR OPTIONAL ISO EXTENDED LEVER: For mounting the optional ISO
Extended Lever, this lever give a quick, flexible and comfortable access to the ISO button, it can be positioned
for thumb or index activation.
43.
TOP ACCESSORY MOUNTING HOLE: A 1/4"-20 TPI hole is supplied to accept a TLC accessory or
TLC base ball for mounting a strobe arm or a modeling light.
44.
GRIP'S ACCESSORIES MOUNTING HOLES: Two 1/4-20 TPI holes on each grip are ready to accept
TLC Base Brackets or TLC Base Ball for strobe arms or accessories.
45.
ACCESSORY BULKHEAD CONNECTION HOLE: For remote control connector and/or other accessories.
46.
ISO / FLASH EXPOSURE COMPENSATION: Press to select ISO sensitivity* or the exposure correction of the flash
* The ISO button can be accessed via the optional ISO Extended Lever (accessory product # 19224). See item # 53
below for more information
47.
AF/ DRIVE SELECTOR BUTTON: press to select either AF Mode or the DRIVE modes options.
48.
METERING PATTERN / WHITE BALANCE MODE BUTTON: Press to select the appropriate metering mode
and/or White Balance mode.
49.
RUBBER ANTI SKID PADS: Four rubber pads are provided to protect the housing and preventing it from
sliding on wet decks.
50.
SACRIFICIAL ANODES: (2X) zinc anodes are installed to protect your housing against salt water corrosion;
theses are made to deteriorate faster than the other strategic metal part of your housing, hence the name
sacrificial anodes. These anodes need to be replaced occasionally by the user over time.
51.
MOUNTING HOLES: Three 1/4" X 20 holes are provided for mounting to a tripod, strobes trays or accessories.
52.
BAYONNET MOUNTING FLANGE: Allows the mounting of different ports and extension rings on the housing.
53.
OPTIONAL ISO EXTENDED LEVER: This optional lever (accessory product # 19224) is designed to moves the
access to the ISO function closer to the grip, from this position, it can then be adjusted to operate with your thumb
or your index simply by loosening the set screw and rotating the lever on the shaft to the desired position.
Page 6
Advertisement
Table of Contents
