BMW 2007X5 3.0si Owner's Handbook Manual page 113

Activating the switch-on time
Move the controller to the left or right to select
"Timer 1" or "Timer 2", then press the control-
ler.
The switch-on time is activated.
The symbol on the automatic air conditioning
display lights up.
The symbol on the automatic air condition-
ing display flashes to indicate that the system is
on.
The system in question will only be
switched on within the next 24 hours. It
must then be reactivated.<
Remote control*
1
Switching off
2 Switching on
3 LED
4 Aerial
The average reception range is approx. 150 m,
approx. 500 ft.
You can optimise the reception range by
holding the remote control as high in the
air as possible with the aerial pointing upwards.
Do not touch the aerial while switching on and
off.<
Online Edition for Part-No. 01 41 0 013 209 - © 04/07 BMW AG
Switching on
1. Press button 2 until the LED 3 lights up
green.
2. Within about 3 seconds, press button 2
again. The LED 3 flashes green.
The symbol on the automatic air conditioning
display flashes.
Switching off
Press button 1 until the LED 3 lights up red.
1.
2. Within about 3 seconds, press button 1
again. The LED 3 flashes red.
The symbol on the automatic air conditioning
display goes out.
Interference
The remote control handset may fail to function
properly if there is interference from other
equipment or devices which use the same radio
frequency.
Changing the batteries
Change the batteries if the LED no longer lights
up or flashes when the independent ventilation
system or auxiliary heater is switched on or off.
1. Remove the cover for the battery compart-
ment, see arrow.
2. Insert new batteries of the same type. The
installed position of the batteries is marked
on the base of the battery compartment.
3. Fit the cover again.
Dispose of old batteries only at an author-
ised collecting point or hand them in to
BMW Service.<
111