IDEAL Logic SYSTEM 15 Installation And Servicing page 48

63 FaULT FINDINg ChaRT MaIN MENU
In order to assist fault finding the boiler has a 7 segment display. The key to the display codes is as follows:
aLTERNaTINg 'L' and '1'
aLTERNaTINg 'L' and '2'
aLTERNaTINg 'L' and '5'
aLTERNaTINg 'L' and '6'
aLTERNaTINg 'F' and '0'
aLTERNaTINg 'F' and '1'
aLTERNaTINg 'F' and '2'
aLTERNaTINg 'F' and '3'
aLTERNaTINg 'F' and '4'
aLTERNaTINg 'F' and '5'
aLTERNaTINg 'F' and '6'
aLTERNaTINg 'F' and '7'
aLTERNaTINg 'F' and '9'
aLTERNaTINg 'c' and '2'
aLTERNaTINg 'c' and '0'
NO Ch
NO hW
NO DIspLay
Note that production boiler PCBs are factory pre-set to operate for boiler range and output, but when ordering Primary PCB as a
spare, an additional Boiler Chip Card (BCC) MUST also be purchased for your specific boiler range and output.
**If PCB replaced as a spare ensure that the BCC (boiler chip card - small plastic part) is fitted to the PCB otherwise replace PCB.
REsET pROCEDURE - To reset boiler, turn mode knob to reset position and immediately turn knob back to required setting.
48
Fault Finding
FLOW TEMpERaTURE OVERhEaT LOCKOUT
BCC (BOILER ChIp CaRD) NOT FITTED
CONTROL/NO FLOW ThERMIsTOR FaULT
CONTaCT ELECTRICITy pROVIDER
BCC FaULT (BOILER ChIp CaRD)
Ideal Logic System -
gO TO FRaME 64 -
or NO WaTER FLOW LOCKOUT
gO TO FRaME 65 -
IgNITION LOCKOUT
5 REsETs WIThIN 15 MINs -
TURN pOWER OFF aND ON
gO TO FRaME 66 -
FaLsE FLaME LOCKOUT
sEE FRaME 51
gO TO FRaME 67 -
LOW WaTER pREssURE
gO TO FRaME 68 -
FLaME LOss
gO TO FRaME 69 -
FaN FaULT
gO TO FRaME 70 -
gO TO FRaME 71 -
RETURN ThERMIsTOR FaULT
gO TO FRaME 72 -
OUTsIDE sENsOR FaULT
LOW MaINs VOLTagE -
pCB FaULT -
**REpLaCE pCB
gO TO FRaME 73 -
REsET BOILER
gO TO FRaME 74
gO TO FRaME 76
gO TO FRaME 75
Installation and Servicing