Connecting With An Iphone/Ipad Via Wireless Lan; Infrastructure Mode - Yamaha PSR-S670 Reference Manual

Connecting with an iPhone/iPad via Wireless LAN

By using a USB wireless LAN adaptor (sold separately), you can connect the PSR-S670 with an iPhone/iPad
via a wireless network. For general operating instructions, refer to the "iPhone/iPad Connection Manual" on
the website. This section covers only operations that are specific to the PSR-S670.
Before starting operations, make sure that the USB wireless LAN adaptor is connected to the [USB TO
DEVICE] terminal and call up the setup display via [FUNCTION]
[][][E][F] WIRELESS LAN
If the USB wireless LAN adaptor is not recognized by the instrument, "WIRELESS LAN" is not shown. When "WIRELESS LAN" is not shown even though
NOTE
a USB wireless LAN adaptor has been connected, turn the instrument off then on again.

Infrastructure Mode

[1 ]/
[2 ]
[3 ]
[4 ]
9
[5 ]/
[6 ]
[7 ]/
[8 ]
88
PSR-S670 Reference Manual
 [ENTER].
WPS Connects this instrument to the network via WPS. Press this button fol-
lowed by the [7 ] (YES) button, then, press the WPS button on your
access point within two minutes.
MODE Switches to the Access Point Mode.
DETAIL For setting the detailed parameters. After making these settings, press one
of the [7 ]/[8 ] (SAVE) button to actually save them.
IP ADDRESS: Sets the IP address and other related parameters.
OTHERS: Sets the Host name, Time Zone and Daylight Saving Time.
When the instrument is connected to the network with the Infrastruc-
ture Mode, the current time is shown on the Main display.
INITIALIZE Initializes the connection setup to the default factory status.
CONNECT Use the Cursor buttons [][] to select the network, then press the
[ENTER] button. Pressing one of the [7 ]/[8 ] buttons connects
to the selected network.
If you select "Others," this calls up the Manual Setup display in which you
set the SSID, security method, and password. After entering those, press
one of the [7 ]/[8 ] buttons in the Manual Setup display to con-
nect to the network.
NOTE Pressing the TAB [E] and [F] buttons simultaneously updates the network list on the display.
 TAB [F] MENU 2  Cursor buttons