TATA Motors Zest Owner's Manual page 54

03
INSTRUMENTS & CONTROLS
COMBI-SWITCH (LH STALK):
1) Intermittent wipe (- - - - -)
2) Slow Wipe
3) Fast Wipe
4) Push the lever downwards for:
For Flick Wipe
(spring return):
Hold the lever for continuous wipe.
When spring return occurs there will
be 4 wipes of wiper and one more wipe
after 5 seconds to clean traces of wa-
ter on windshield.
54
5) Front Windshield
Washer :
a. Pull the lever little longer, washer
fluid will be sprayed on the windshield.
b. The windshield wipers operate for 3
cycles after the lever is released and
1 more cycle after 5 seconds.
c. When you crank the vehicles
engine, the supply to washer motor is
momentarily cut off.
6) Rear Wash and Wipe Rotary
Switch :
( )
( )
Rear Windshield Wiper
and Washer Switch:
Turn the rotary knob clockwise andhold
it, to operate rear windshield wash and
COMBI-SWITCH
wipe. It will return to 'OFF'position as
soon as released.
Rear Wipe:
Turn the rotary knob Counter clockwise
such that it aligns its positions with
arrow mark to operate rear windshield
wash and wipe. It will return to 'Rear
Wipe' position as soon as released.
Rear wiper will start wiping continu-
ously.
Rear Windshield Wiper
and Washer Switch:
Turn the rotary knob counter clock-
wise such that it aligns its positions
with arrow mark and hold it, to operate
rear windshield wash and wipe. It will
return to 'Rear wipe' position as soon
as released.
WARNING
If you operate wash and wipe
function for more than 15 seconds
the controller cuts off the supply to
washer motors to avoid overheating.