Travis Industries 21 TRV B05Ef9D3Fa7Ab2866Ccd708D760E page 8

564 DF GSR2 SCR
Framing
Guide
TRAVIS INDUSTRIES
HOUSE OF FIRE
12521 HARBOUR REACH DRIVE
MUKILTEO, WA 98275-5458
Minimum Framing Dimensions - Rear Vent Configuration
HINT: place the fireplace so the center
line is at least 5" (127mm) from both
vertical framing members at the rear (this
allows the vent to pass through the
framing without modfications)
Minimum 38" (965mm)
Fireplace Enclosure Height
Route the
electrical line to
a position to the
left rear of the
33-1/2"
fireplace.
851mm
/.�
36-1/2"
927mm
Corner Installations - Rear Vent Configuration
A typical 45 ° installation uses the framing dimensions shown in the illustration below (NOTE: all
clearances still apply).
7"(178mm)
Approximate
(varies due to vent
installation) __
6" (152mm) Section for 2x6
(51 mm X 152mm) Walls
4" (102mm) Section for 2x4
(51mm X 102mm) Walls
45-3/4"
Top Vent Configuration
8" (203mm) Diameter Vent
28-1/2"*
724mm
<
16-3/4"
426mm
* Includes the required 1/2" (13mm)
clearance.
Included Firestop (required)
Part# 250-00747
Vent Clearances for B" (203mm) dia. Vent:
1" (25mm) to the sides, 1" (25mm) below,
and 4" (102mm) above the vent to
combustibles
ki · · Center of Rear Vent
.- ·
'J /
24-1/4"
616mm
= �
[
17-1/4"
The on/off switch/thermostat wire (if
y� /'
used) should be routed to a location
near the right front of the fireplace.
564 SS Firestop
Minimum 1" (25mm)
Clearance
845mm
Minimum Framing Dimensions - Top Vent Configuration
Route the electrical line to
a position to the left rear
of the fireplace.
33-1/2'
851mm
....<'" �
36-1/2"
927mm
Minimum enclosure height= 38
Corner Installations - Top Vent Configuration
A typical 45• installation uses the framing dimensions shown in the illustration below (NOTE: all
clearances still apply)
45-3/4"
Weight: 155 Lbs. (70.4kg)
The on/off switch/thermostat wire (if
used) should be routed to a location
near the right front of the fireplace.
WARNING: A cut- o ut for the gas line
may be required on the framing. See
the dimensions under "Gas Line
Connection" for details.
Minimum 1/2" (13mm)
Clearance