Toro Sand Pro 2040Z Service Manual page 81

1. Input shaft kit
2. Pump/motor kit
3. Thrust bearing kit
4. Brake kit
5. Charge pump kit
NOTE: The illustration shown in Figure 47 shows the
transmission used on the right side of the Sand Pro
2040Z. This transmission includes several components
necessary for operation of the rear lift cylinder that are
not necessary on the transmission used on the left side
of the machine. Component parts groups are identified
in Figure 47 because individual parts are not available
separately. Refer to your parts catalog for part numbers
for transmission component groups.
Sand Pro 2040Z
Figure 47 (Continued)
6. Fastener kit
7. Drive gear kit
8. Axle kit
9. Inner filter kit
10. Auxiliary port kit
NOTE: For transmission repair information, see the
Model TZT13 Tuff Torq Transaxle Service Manual at the
end of this Chapter.
IMPORTANT: If pulley (item 15) or wheel hub (item
14) is to be removed during transmission disassem-
bly, make sure that correct removal tool is used so
component will not be damaged during removal
(see Special Tools in this chapter).
Page 4 - 51
11. Bypass valve kit
12. Trunnion kit
13. Seal kit
14. Axle hub kit
15. Pulley/fan kit
Hydraulic System