Toro Sand Pro 2040Z Service Manual page 121

Removal (Fig. 11)
1. Park machine on a level surface, lower rear attach-
ment, stop engine, apply parking brake and remove key
from ignition switch.
2. Remove four (4) flange head screws (item 3) and flat
washers (item 4) that secure seat support plate to ma-
chine frame.
3. Carefully tilt seat support plate up and disconnect
wire harness connector from the seat switch located on
the bottom of the seat. Also, remove cable tie that se-
cures wire harness seat switch lead to seat support
plate.
4. Remove seat support plate with attached seat from
machine.
5. Remove four (4) flange nuts (item 6) that secure seat
to seat support plate. Separate seat from support plate.
6. Disassemble seat as necessary using Figures 12
and 13 as guides.
Installation (Fig. 11)
1. Assemble seat using Figures 12 and 13 as guides.
2. Secure seat to seat support plate with four (4) flange
nuts.
3. Make sure that clip nuts (item 5) are properly posi-
tioned on frame.
4. Secure support plate with attached seat to machine
A. Position support plate to machine frame.
B. Connect wire harness connector to the seat
switch. Secure wire harness seat switch lead to seat
support plate with cable tie.
C. Align support plate to clip nuts on frame and se-
cure with four (4) flange head screws and flat wash-
ers.
Sand Pro 2040Z
14
3
2
1. Seat frame
2. Bottom cushion
3. Back cushion
4. Bolt (7 used)
5. Flange nut (4 used)
6. Washer (4 used)
7. Spacer (4 used)
8. RH seat adjuster
RIGHT HAND ARM REST ASSEMBLY SHOWN
1
2
7
1. Arm rest cushion
2. Flat washer (2 used)
3. Cap screw
4. Arm rest channel
Page 6 - 15
15
12
13
11
5
6
1
7
10
8
Figure 12
9. LH seat adjuster
10. Seat switch
11. Seat belt
12. Seat belt latch
13. Cap screw (2 used)
14. Hex nut (2 used)
15. RH arm rest assembly
16. LH arm rest assembly
5
4
3
6
Figure 13
5. Hex nut
6. Arm rest bracket
7. Cap screw (4 used)
8. Lock nut (2 used)
16
4
14
9
7
8
Chassis