Toro Sand Pro 2040Z Service Manual page 79

B. Position new O- rings and connect hydraulic lines
to fittings on RH transmission (see Hydraulic Hose
and Tube Installation in the General Information sec-
tion of this Chapter). As hydraulic lines are being
tightened, use wrench on transmission fittings to pre-
vent them from tightening into transmission.
7. Install transmission drive belt (see Transmission
Drive Belt in this section).
8. Install rear wheel (see Rear Wheels in the Service
and Repairs section of Chapter 6 - Chassis).
9. Make sure that two (2) transmission drain plugs
(pump side and gear drive side) are properly tightened
(Fig. 43).
IMPORTANT: Use only hydraulic fluids specified in
Operator's Manual. Other fluids could cause system
damage.
10.Fill hydraulic reservoir and transmission with new hy-
draulic oil to proper level.
Sand Pro 2040Z
11. Properly fill hydraulic system (see Charge Hydraulic
System in this section).
12.Stop engine and check for hydraulic oil leaks. Check
hydraulic reservoir oil level and adjust if necessary.
13.Check adjustments for control handle position, neu-
tral position, control handle dampening and neutral lock
resistance (refer to Operators Manual). Also, make sure
that traction interlock system correctly prevents engine
starting and operation when motion control handles are
not in the neutral locked position.
Page 4 - 49 Hydraulic System