Toro Sand Pro 2040Z Service Manual page 117

Removal (Fig. 6)
1. Park machine on a level surface, lower rear attach-
ment, stop engine and remove key from ignition switch.
2. Make sure parking brake is disengaged.
3. Remove parking brake components as needed us-
ing Figure 6 as a guide.
Installation (Fig. 6)
1. Install removed parking brake components using
Figure 6 as a guide. Also, use the following adjustment
dimensions and Figures 7, 8 and 9 during assembly:
A. If carriage bolt (item 1 in Fig. 6) was removed from
brake handle bracket, adjust head of bolt so that it is
from 0.640" to 0.760" (16.3 to 19.3 mm) from brake
handle bracket.
B. If ball joint or hex nut was removed from brake rod
(item 30 in Fig. 6), make sure that the balljoint cen-
ters measure from 9.040" to 10.060" (229.7 to
255.5 mm) and that the balljoints are parallel.
C. If brake rod (item 11 in Fig. 6) was removed from
brake shaft, engage parking brake and adjust length
of compression spring from 1.875" to 2.125" (47.7
to 53.9 mm) measured at top of brake shaft bracket.
Sand Pro 2040Z
0.640" to 0.760"
(16.3 to 19.3 mm)
3
1. Carriage screw
2. Lock nut
1 2
1. Balljoint
2. Hex nut
SPRING COMPRESSION WITH BRAKE ENGAGED
1
5
1. Brake rod
2. Lock nut
3. Flat washer
Page 6 - 11
2
Figure 7
3. Jam nut
4. Brake handle bracket
3 2
9.040" to 10.060"
(229.7 to 255.5 mm)
Figure 8
3. Brake rod
1.875" to 2.125"
(47.7 to 53.9 mm)
2
3
4
Figure 9
4. Compression spring
5. Brake shaft bracket
1
4
1
Chassis