Toro Sand Pro 2040Z Service Manual page 61

6. Loosen hose clamp and disconnect hydraulic hose
from hydraulic reservoir outlet. Put plug in disconnected
hose to prevent contamination.
7. Remove two (2) flange head screws and flange nuts
(items 5 and 6) that secure hydraulic reservoir to the
reservoir bracket.
8. Remove hydraulic reservoir from machine.
9. If necessary, remove hydraulic hose (item 9) from
transmission fitting:
A. Thoroughly clean end of hydraulic hose at trans-
mission fitting to prevent system contamination.
B. Loosen hose clamp and disconnect hydraulic
hose from transmission fitting.
C. Put plug in transmission fitting to prevent system
contamination.
Inspection
1. Clean hydraulic reservoir with solvent.
2. Inspect reservoir for leaks, cracks or other damage.
Installation (Fig. 27)
NOTE: If fitting (item 10) was removed from transmis-
sion, install new O-ring (item 12) into transmission port
and ensure O-ring is bottomed completely against
shoulder in transmission before installing fitting into
port. Secure fitting to transmission with flange head
screw (item 11) and torque screw from 17 to 21 ft- lb (23
to 28 N- m).
1. If removed, install hydraulic hose (item 9) to trans-
mission fitting:
A. Remove plug from transmission fitting that was
placed to prevent system contamination.
B. Connect hydraulic hose to transmission fitting
and secure with hose clamp. Make sure that hy-
draulic hose is routed through frame hole with grom-
met.
2. Position hydraulic reservoir to reservoir bracket.
Sand Pro 2040Z
3. Remove plug that was placed to prevent contamina-
tion from hydraulic hose. Connect hydraulic hose to hy-
draulic reservoir outlet and secure with hose clamp.
4. Secure hydraulic reservoir to the reservoir bracket
with two (2) flange head screws and flange nuts (items
5 and 6).
5. Make sure that two (2) transmission drain plugs
(pump side and gear drive side) are properly tightened
(Fig. 28).
IMPORTANT: Use only hydraulic fluids specified in
Operator's Manual. Other fluids could cause system
damage.
6. Fill hydraulic reservoir and transmission with new hy-
draulic oil to proper level.
7. Properly fill hydraulic system (see Charge Hydraulic
System in this section).
8. Stop engine and check for hydraulic oil leaks. Check
hydraulic reservoir oil level and adjust if necessary.
VIEW FROM REAR OF MACHINE
1
2 3 4
1. LH transmission
2. LH gear side drain
3. LH transmission filter
4. LH pump side drain
Page 4 - 31
5
8 7
Figure 28
5. RH transmission
6. RH gear side drain
7. RH transmission filter
8. RH pump side drain
Hydraulic System
6