Kenmore 501-80002 Owner's Manual page 23

Table of Contents

Advertisement

Available languages

Available languages

T
roubleshooting Guide
4.Problem:There is Lint on my Clothes
Question
• Is your lint filter full?
• Did you properly sort your load of
laundry?
• Do your clothes have excess static
electricity?
• Did you overload your dryer?
• Did you place any paper, tissue, or
other similar material in the load?
5.Problem:There is static in my clothes after drying
Question
• Did you use fabric softener?
• Did you over dry the load of
laundry?
• Are you drying synthetic, permanent
press and blends?
6.Problem:The drying time is not consistent
Question
• Are you using consistent heat
settings and consistent load sizes?
Please refer to the manual section on cleaning the lint filter, and please confirm
that the lint filter is clean. It is important that the lint filter is clean before each
new load of laundry.
In order to reduce the amount of lint in a load of laundry, sort lint producers (like
a fuzzy white cotton towel) separately from clothes that might catch lint (such as a
pair of black linen pants).
See comments below under There is static in my clothes after drying.
Divide your larger load into smaller loads.
Sometimes a person might forget to take a piece of paper or a tissue out of the
pocket of a pair of pants, and this paper, tissue, or similar material can cause
excess lint in a load of laundry. Confirm that the pockets of pants, shirts, and
other articles of clothing are empty before washing and drying.
Try using a fabric softener to reduce static electricity.
Over-drying a load of laundry can cause a build up of static electricity. Try
using a fabric softener or adjust your settings and use a shorter drying time.
These materials can cause static to build up in a load of dried clothes. Try
using a fabric softener.
The drying time for a load will vary depending on the heat setting, the type of
heat used (electric, natural or LP gas), the size of the load, the type of fabrics, the
wetness of the clothes and the condition of the exhaust ducts and lint filer.
What to Do
What to Do
What to Do
F
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents