Alarm Operation; Dimmer Control; Sleep Function - Jensen JCR-295 User Manual

SETTING THE ALARM TIME
You can set two different alarm times and select wake to RADIO / ALARM sound.
1. In standby mode, press and hold the ALARM 1 Button (#12) until the LED display
flash.
2. Press the MIN / HR Buttons (#6) to set the hour and minute of the alarm time.
3. Press the ALARM 1 Button (#12) to confirm the alarm time. LED display resume display
the current time.
4. Alarm 2 setting procedures are same as Alarm 1.
Note : If Alarm 1 and Alarm 2 set at same time, only Alarm 2 will function.
SETTING WAKE TO ALARM OR RADIO
1. In standby mode, press the ALARM 1 Button (#12) repeatedly to set alarm 1
a. Wake to Alarm, Alarm 1 WAKE to ALARM Indicator (#2) will light up.
b. Wake to Radio, Alarm 1 WAKE to Radio Indicator (#2) will light up.
c. Alarm 1 Off, both WAKE to ALARM & RADIO Indicators light off
2. When alarm sounds, press POWER /FUNCTION Button (#5) once to stop the alarm
and it will repeat next day same time.
3. When alarm sounding after one hour, the sound will auto off and repeat next day.
4. Alarm 2 wake to Alarm or radio setting procedures is same as Alarm 1.
STOP THE ALARM SOUND
When alarm sounds, press POWER/FUNCTION Button (#5) once to stop the alarm and it
will repeat next day same time.
COMPLETELY TO TURN OFF ALARM (NOT RESET FOR NEXT DAY)
In standby mode, press the ALARM 1 / ALARM 2 Buttons (#12) repeatedly until the alarm
wake up ALARM and RADIO indicators (#2 & #11) light off.
CHECKING THE ALARM TIME
In standby mode, press and hold the ALARM 1 or ALARM 2 Button (#12) until the alarm
time shows.
SNOOZE ALARM
After the radio or alarm sounds, you may press the SNOOZE button (#16) for a few
more minutes sleep. The alarm will stop for approximately 9 minutes and then turn on
again.
Press the DIMMER Button (#14) briefly to select LED DISPLAY (#9) brightness.
This function allows you to program the system to turn itself OFF after a set period of time. You
can set your sleep time while in Power On ( Radio, AUX or Bluetooth ) mode:
1. To activate the sleep function, press the SLEEP button (#16) repeatedly on the unit, the
display will show "90, 80, 70, 60, 50, 40, 30, 20, 10, OFF in sequence.
2. When the display shows your desired sleep time, release the button, the sleep timer is now
activated, the SLEEP Indicator will Turn On. The display show "10" is to indicate "10 minutes"
sleep time and so on. When the sleep time counts to zero, the unit will go off.

ALARM OPERATION

DIMMER CONTROL

SLEEP FUNCTION

E-7