Battery Installation - Motorola SBV5220 User Manual

Introduction

Battery Installation

Before you begin the installation, you must first install the battery in your VoIP cable modem. Please read
Requirements for the SBV5220 Lithium-Ion Battery"
1
Place the SBV5220 on its side and remove the battery cover on the bottom.
Battery Installation
2
Slide the battery into the battery compartment until it is fully seated. The battery is keyed so that it cannot be
installed incorrectly. Make sure that the pull-tab on the battery is accessible and does not prevent the battery
cover from closing properly.
3
Re-install the battery cover with the locking tabs seated downward, and then push the cover forward.
It may take up to 12 hours to reach full charge when:
•
The battery is installed for the first time.
•
The battery is replaced.
•
The battery is fully discharged.
SBV5220 VoIP Cable Modem User Guide
Installation Troubleshooting
on page iv before proceeding.
Glossary License
"Safety
9