Table of Contents
Advertisement
RECEIPT INSPECTION
After unpacking the equipment, check the contents against the packing
list. Inspect the equipment carefully for damage that may have occurred
in shipment. If there is damage or material shortage, contact the ship-
ping agent and Motorola for advice and assistance. You should keep the
shipping container and packing material for future shipment.
SITE PREPARATION
Install the unit within 6 feet of a 115 or 230 Vac grounded outlet as
required for the specific model and no further than 50 feet from the
terminal equipment.
The installation area should be clean, well lighted, and free from
extremes of temperature, humidity, appreciable shock, and vibration.
Allow sufficient space at the rear of the unit for signal line and interface
cable clearance.
HARD OPTIONS
The PC card has two strap options that should be verified or changed
prior to installation. These options are factory set for standard installa-
tions. The factory options are described in Chapter 4. If a hard option
requires changing, follow the instructions in Chapter 4 before
continuing installation.
INSTALLATION
Figure 2-1 and Figure 2-2 illustrate typical installation.
• Connect the DTE cable to the 25-pin DTE connector. Secure the
two screws to complete the connection.
• Connect the opposite end to the DTE port.
• Insert the 8-pin plug into the rear panel DDS jack labeled DDS.
• Insert the opposite end into the TELCO DDS system.
• Plug in the ac power cord.
• Place the power switch ON.
DDS/MR64
Chapter 2
Installation
2-1
Advertisement
Table of Contents
