Remote Control - ProScan PSB379 Instruction Manual

39 inches bluetooth sound bar speaker with wireless subwoofer
Table of Contents

Advertisement

Available languages

Available languages

REMOTE CONTROL

1. SOURCE Butto
2. Standby Button
(Previous)
3.
TUNE-(Tune Down)
(Next)
TUNE+(Tune Up)
4. VOL-/+(Volume Down/Up)
5.
Mute Button
P
lay/Pause Button
6.
7. ST/MO(Stereo/Mono) Button
8. EQ(Equalizer)
BATTERY INSTALLATION
- Before installation
Remove and discard the insulation tab. Out of the box the Remote Control
has a battery and will be usable after the tab is removed.
-Replace battery for the remote control
1. Push and slide out the battery holder as Figure 1 below.
2. Replace the battery with a new CR2025 button cell with the polarity (+)
side upward.
3. Slide into the battery holder.
Battery precautions
• Never recharge the batteries, apply heat to them or take them apart.
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• Do not throw the batteries in fire!
• Attention should be drawn to the environmental aspects of battery disposal.
• If the remote control is not going to be used for a long time, remove the battery
to avoid damage caused by battery leakage corrosion.
POWER CONTROL
- To turn the unit on
• Connect the supplied AC/DC adapter.
• Press STANDBY button to turn on the unit.
- To turn the unit off
• Press STANDBY button on the remote control.
NOTE:
If the unit is not used for a long period of time, disconnect the power adapter.
1
n
2
3
4
POWER
l
SOURCE
TUNE+
TUNE-
VOL
-
+
EQ
6
5
6
7
ST/MO
8

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PSB379 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents