Using The Battery Monitor - Waeco CoolFreeze CFX95DZ2 Instruction Manual

CFX95DZ2
Connecting to a 100–240 V AC mains (e.g. in the home or office)
D
DANGER! Danger of electrocution!
 Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
 If you are operating your cooler on board a boat from a mains
connection of 100 – 240 V~, you must install a residual current
circuit breaker between the 100 – 240 V~ mains and the
cooler.
Seek advice from a trained technician.
The coolers have an integrated multi-voltage power supply with priority circuit
for connecting to an AC voltage source of 100 – 240 V. The priority circuit
automatically switches the cooler to mains operation, if the device is con-
nected to an AC mains, even if the DC connection cable is still attached.
➤ Plug the AC connection cable (fig. 1 3, page 6) into the device AC
voltage socket and connect it to the AC voltage mains.
7.4

Using the battery monitor

The device is equipped with a multi-level battery monitor that
protects your vehicle battery against excessive discharging when
the device is connected to the on-board DC supply.
If the cooler is operated when the vehicle ignition is switched off, the cooler
switches off automatically as soon as the supply voltage falls below a set
level. The cooler will switch back on once the battery has been recharged to
the restart voltage level.
A
NOTICE! Danger of damage!
When switched off by the battery monitor, the battery will no
longer be fully charged. Avoid starting repeatedly or operating
current consumers without longer charging phases. Ensure that
the battery is recharged.
EN
Operation
15