Toyota 2008 4Runner Owner's Manual page 336

07 12.25
6. Test the operation of the HomeLink
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink R button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
Individual HomeLink R buttons cannot be
erased, however, to reprogram a single
button, follow the procedure "Programming
the HomeLink R ".
R
(b) Operating the HomeLink
To operate the HomeLink R , press the
appropriate HomeLink R button to activate
the programmed device. The HomeLink
indicator light should come on.
HomeLink R continues to send the signal
for up to 20 seconds as long as the
button is pressed.
R by
CY19133
(c) Erasing the entire
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
R
memory.
The
For additional programming assistance
with your HomeLink
Transceiver call the:
The Toyota
D
Center at 1−800−331−4331 (U.S.A.)
Toyota Canada
D
Centre at 1−888−869−6828 (Canada)
Refer to HomeLink R
WWW.HOMELINK.COM
HomeLink R
R
R Universal
Customer Experience
Customer Interaction
on the internet at:
321