Setting Up The Video Input Jacks; Setting Up The Ant/Cable In Jack; Setting The Rgb Range For Hdmi Jacks - Toshiba 28L110U Instruction Manual

28L110U/32L110U Toshiba 28"/32" 720p 60Hz LED TV
Setting up the video input
jacks
This section includes topic about:

• Setting up the ANT/CABLE IN jack

• Setting the RGB range for HDMI jacks

Setting up the ANT/CABLE IN jack
If you connect an antenna or cable TV without a box
to the ANT/CABLE IN jack, you need to set up the jack
so your TV correctly displays channels.
1 Press MENU, press
Installation, then press ENTER.
2 Highlight Channel Tuning, then press ENTER.
3 Highlight ANT/CABLE In, then press ENTER.
4 Highlight your TV input source, then press ENTER.
Select:
• Antenna if you connected an antenna to the
ANT/CABLE IN jack
• Cable if you connected cable TV without a box
to the ANT/CABLE IN jack
5 Press EXIT to close the menu.
or to highlight
www.tv.toshiba.com
Setting the RGB range for HDMI jacks
You can select the RGB range for the HDMI jacks.
Note
If your HDMI device does not support the
HDMI RGB Range feature, your TV may not
work correctly when you turn on this
feature.
1 Press MENU, press
then press ENTER.
2 Highlight Input Options, then press ENTER.
3 Highlight HDMI 1 RGB Range or HDMI 2 RGB
Range, then press ENTER.
4 Highlight an option, then press ENTER. Select:
• Auto—(Default) Adjusts the RGB full range
signal automatically.
• Full—The RGB input signal is displayed in the
range of 0 to 255.
• Limited—The RGB input signal is displayed in
the range from 16 to 235.
5 Press EXIT to close the menu.
or to highlight Options,
41