JVC PD-50X795 Service Manual page 73

Quick Setup
Auto Tuner Setup
In auto tuner setup, the TV automatically scans through all available channels, memorizing the
active ones and skipping over blank ones or channels with weak signals. This means when you
scan (using the C
HANNEL
two tuner modes to choose from, ANALOG or DIGITAL.
AUTO TUNER SETUP
IN ANALOG
TUNER MODE
IN DIGITAL
TUNER MODE
START
SELECT OPERATE
Now Programming...
20
When the setup is finished, "THANK YOU ! SETUP IS NOW COMPLETE" is displayed. Your
quick setup is now complete. You can now begin watching your television, or you can continue
on in this guide for more information on programming your remote control, or using the
JVC onscreen menu system to customize your television viewing experience.
Notes:
• If you want to cancel the Auto Tuner Setup, press the M
• Noise muting will not work during Auto Tuner Setup.
• If you choose SKIP, it finished without doing the Auto Tuner Setup.
Cable Box and Satellite Users: After your auto tuner setup is complete, you may, (depending
on the type of hookup), have only 1 channel, usually 3 or 4 in the auto tuner memory. This is
normal.
STOP
32
+/– buttons) you will receive only clear, active channels. There are
è
AIR
π †
è
ATSC
†
After Analog Auto Tuner Setup is finished, Digital Auto
EXIT
MENU
Tuner Setup starts.
The Quick Setup is complete
Plug-In Menu
To choose CABLE or AIR (or SKIP when
you skip Analog Auto Tuner Setup)
To TUNER MODE (IN DIGITAL)
To choose ATSC or Digital Cable (or SKIP
when you skip Digital Auto Tuner Setup)
To START
PROGRAMMING !
button.
ENU
NOW
48