Disassembly Instructions - Mitsubishi MCFH-13NV Service Manual

12

DISASSEMBLY INSTRUCTIONS

"w" shows the terminals with a lock mechanism,
so they cannot be removed when you pull the
lead wire.
Be sure to pull the wire by pushing the locking
lever (project part) of the terminal with a finger.
12-1.MCFH-13NV-
INDOOR UNIT
OPERATING PROCEDURE
1. Removing the electronic control P. C . board.
(1) Pull out the upper part of the grill. ( photo 1 )
(2) Remove the screws of the grill.
(3) Remove screws of terminal block cover.
Remove the terminal block cover and remove the terminal
block.
(4) Remove the screws of the electronic box cover.
(5) Pull out the electronic control P. C. board.
Photo 3
Electronic control P.C. board
2. Removing the indoor fan motor
(1) Remove the grill. ( Refer to 1(1) (2) )
(2) Remove the screws of the pipe support assembly.
(3) Remove the fan casings.(upper) .
(4) Disconnect the connector of the indoor fan motor.
(5) Disconnect the ground wire of the fan motor.
(6) Remove the screws of the motor band and remove the
catch.
(7) Take out the sirocco fan and the indoor fan motor .
, MCFH-18NV-
E4 E3
1Slide the sleeve.
2Pull the wire while pushing the locking lever.
, MCFH-24NV-
E3
Photo 1
Photo 2
Electronic box
Photo 4
Fan casing
(upper)
Indoor fan motor
55
PHOTOS
Screws
Terminal block
Motor band
Fan
casing(upper)
Screws