12-4. MUCFH-24NV -
OUTDOOR UNIT
OPERATING PROCEDURE
1. Removing the electrical parts
( 1 ) Remove the 5 screws and the top panel. ( 3 screws in
front and 2 screws in rear )
( 2 ) Remove the screw of the cover panel. To remove the
cover panel, pull it toward you and unhook the catch-
es from the side panel.
( 3 ) Remove the screw of the service panel. To remove the
service panel, pull it down toward you and unhook the
catches on the both sides.
2. Removing the fan motor
( 1 ) Remove the 3 screws of the front panel. Open the
front panel to a 45-degree angle.
unhook the 3 catches to remove.
( 2 ) Remove the propeller nut and the propeller.
( 3 ) Remove the 3 screws and the fan motor.
Disconnect the lead connectors.
E3
Then lift it and
Photo 1
Screws
Front panel
Photo 2
Deicer P.C. board
Screws
Photo 3
Motor support
Propeller
fan
Propeller nut
61
PHOTOS
Top panel
Service panel
Panel cover
Fan motor
capacitor
Transformer
Contactor
Terminal block
Separator support plate
Lead
connectors
Valve bed