Replacing The Converter Board - Lenovo ideacentre 700–24ISH Hardware Maintenance Manual

Step 10. To reattach the middle cover:
a. Line up the middle cover with chassis, and then place the middle cover back.
b. Secure the middle cover to the chassis with the screws.
Step 11. Reattach the stand holder, optical drive, foot cover and stand base.

Replacing the converter board

Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches
or other damage.
To replace the converter board:
Step 1. Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
Step 4. Remove the stand base. Refer to "Removing the stand base".
Step 5. Remove the foot cover. Refer to "Removing the foot cover".
Step 6. Remove the stand holder. Refer to "Removing the stand holder".
Step 7. Remove the middle cover. Refer to "Removing the middle cover".
.
Chapter 8 Replacing hardware
35