Removing The Stand Base - Lenovo ideacentre 700–24ISH Hardware Maintenance Manual

Step 2. Unplug the power cord from electrical outlet
connector on the computer
1
Step 3. Connect the new power cord as shown.

Removing the stand base

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the touch screen from scratches
or other damage.
Step 1. Remove any media (disks, CDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
1 , and then disconnect the power cord from the
2 .
2
1
.
Chapter 8 Replacing hardware
27