Replacing Battery - Toyota 2008 Camry Solara Owner's Manual

—Switching beep sound
You can switch the beep on and off. (The
beep is on initially and after battery re-
placement.)
To switch the beep on and off:
With the driver's door opened—
1. Insert the ignition key and remove it.
2. Within 5 seconds, insert the engine
switch again and turn it to the "ON"
position.
3. After 10 seconds, push any switch on
the transmitter twice within 10 seconds.
Two beep sounds inform you that the
program has been switched on or off.
If this procedure is not followed exactly,
the beep will not operate as expected.
Check the beep ON/OFF operation by
pushing the transmitter switch after you
finish this procedure. If the beep does not
operate as expected, repeat this proce-
dure from step 1.
'08 Solara_U (L/O 0802)

—Replacing battery

For replacement, use a CR2032 lithium
battery or equivalent.
CAUTION
Special care should be taken to pre-
vent small children from swallowing
the removed transmitter battery or
components.
NOTICE
z When replacing the transmitter bat-
tery, be careful not to lose the com-
ponents.
z Replace only with the same
equivalent type recommended by a
Toyota dealer.
z Dispose of used batteries according
to the local laws.
Replace the transmitter battery by follow-
ing these procedures:
1. Using a coin or equivalent, open the
transmitter case.
or
2008 CAMRY SOLARA from Feb. '08 Prod. (OM33810U)
19