Toyota 2008 Camry Solara Owner's Manual page 258

The ceiling mounted garage door opener
motor should now recognize
HomeLink R unit and be able activate the
garage door up/down.
4. Repeat steps 1 through 3 for each re-
maining HomeLink R button to program
another rolling code system.
Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
tons you want to program.
2. Place your hand−held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface
HomeLink R .
Keep the indicator light on the HomeLink
in view while programming.
3. Press and hold the
HomeLink R button.
4. Continuously press and release (cycle)
the hand−held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator light
HomeLink R changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
250
6. Test the operation of the HomeLink
the pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink R
another device.
Programming other devices
To program other devices such as home
R but- security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
of the
Individual HomeLink R
erased, however, to reprogram a single
R button, follow the procedure "Programming
the HomeLink R ".
selected (b) Operating the HomeLink
To operate the HomeLink
appropriate HomeLink R
the programmed device. The HomeLink
indicator light should
HomeLink R continues to send the signal
for up to 20 seconds as long as the
on the
button is pressed.
'08 Solara_U (L/O 0802)
R by
button to program
Coupe
buttons cannot be
R
R , press the
button to activate
R
come on. The
Convertible
2008 CAMRY SOLARA from Feb. '08 Prod. (OM33810U)