Toyota 2008 Camry Solara Owner's Manual page 169

TIRE PRESSURE WARNING
SWITCH
When initializing the system, the present
tire inflation pressure is stored as stan-
dard. The tire pressure warning system
determines decreased air pressure
comparing the present and the standard
tire inflation pressures. When you change
the set tire inflation pressure, it is neces-
sary to initialize the tire pressure warning
system.
When changing the tire size.
D
When rotating the tire on vehicles dif-
D
fering with front and rear tire inflation
pressure.
When changing the tire inflation pres-
D
sure by changing traveling speed or
load weight, etc.
To initialize the system, perform the fol-
lowing:
1. Park the vehicle in a safe place and
turn the engine switch to "LOCK" posi-
tion.
2. Adjust the pressure of all the installed
tires to the specified cold tire inflation
pressure level. (See "Tires" on page
377 in Section 8.)
3. Turn the engine switch to the "ON"
RESET
position.
4. Push and hold the tire pressure warn-
ing reset switch until the tire pressure
warning light blinks slowly three times.
5. Wait for a few minutes with the engine
by
switch in "ON" position, and then turn
the engine switch to the "LOCK" posi-
tion.
If you push the tire pressure warning re-
set switch while vehicle is moving, initiali-
zation is not performed.
If you push the tire pressure warning re-
set switch accidentally and initialization is
performed, adjust the tire inflation pres-
sure to the specified level and initialize
the system again.
'08 Solara_U (L/O 0802)
If the tire pressure warning light does not
blink slowly three times when you push
and hold the tire pressure warning reset
switch, initialization has failed and the tire
pressure warning system may not work
properly. In this case, initialize the system
again. If initialization cannot be performed,
have the system checked at your Toyota
dealer.
2008 CAMRY SOLARA from Feb. '08 Prod. (OM33810U)
161