Toyota 2008 Camry Solara Owner's Manual page 259

(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
For additional programming assistance
with your HomeLink R Universal
Transceiver call the:
Toyota Customer Experience Center at
D
1−800−331−4331 (U.S.A.)
Toyota Canada Customer Interaction
D
Centre at 1−888−869−6828 (Canada)
'08 Solara_U (L/O 0802)
R Refer to HomeLink R on the internet at:
WWW.HOMELINK.COM
CAUTION
When programming the HomeLink
D
Universal Transceiver, you may be
operating a garage door or other
R
device. Make sure people and ob-
jects are out of the way of the ga-
rage door or other device to pre-
vent potential harm or damage.
Do not use this HomeLink
D
sal Transceiver with
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes any garage
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
This device complies with Part 15 of the
FCC Rules and with RSS−210 of the IC
Rules. Operation is subject to the fol-
lowing two conditions: (1) This device
may not cause harmful interference, and
R
(2) this device must accept any interfer-
ence received,
that may cause undesired operation.
WARNING: This transmitter has been
tested and complies with FCC and IC
rules. Changes or modifications not
expressly approved by the party re-
R Univer-
sponsible for compliance could void
any garage
the user's authority to operate the
device.
door
2008 CAMRY SOLARA from Feb. '08 Prod. (OM33810U)
including interference
251