Chapter 2 System Utilities& Configuration; System Utilities; Before Using System Utilities And Video Drivers; Using Utilities & Video Drivers - Digital Equipment STARION 200i Service Maintenance Manual

Digital STARION 200i/300i PC
Chapter 2 System Utilities& Configuration

System Utilities

This chapter describes how to use the utilities and video drivers supplied with the STARION 200i/300i
computer. These utilities and drivers have been factory installed on the hard disk drive. You may use the
video utilities to change video graphics settings of the monitor.
programsand device drivers have also been factory installed as image files on the hard disk drive. This
chapter also describes PHLASH.EXE, which is not supplied with the computer. This utility is available
only via bulletin board distribution to customers needing BIOS upgrades.

Before Using System Utilities and Video Drivers

When unfamiliar with utility programs, video drivers and their uses, carefully read and understand this
chapter before attempting to use any of the utilities or to install video drivers.
Using Utilities & Video Drivers
The system utilities and video drivers enable to take full advantage of the computers enhanced video
features. Use the following information to reset the video mode of the monitor, or to load MS-DOS
application drivers when using various non-Windows CAD or business software.
NOTE If this is the first time using these utility programs and/or video drivers, it is
recommended to follow the procedures in the order given.
1) Turn on or reboot the computer. If POST detects an error, refer to chapter 4, "Troubleshooting" for
possible causes and suggested solutions.
2) If necessary, run PHLASH.EXE to upgrade or restore the computer's BIOS.
MCS Logistics Engineering - Nijmegen
Utilities & Configuration
Additional video drivers, utility
15
S
T
A
R
I
O
N
2
0
0
i
3
0
0
i