Placing A Call - Motorola 9505 User Manual

Placing a Call

Tip: If you
make a
mistake, press
C
once to
delete the last
digit, or press
C
and hold to
clear all digits.
46 Using Your Phone
To place a call, your phone must be powered on,
have a SIM card inserted, be unlocked, and be in
contact with the satellite or cellular network
(depending on your mode). See "Accessing the
Network" on page 177 for network information.
You can enter a phone number up to a maximum of
20 digits. The digits are displayed in two rows, 16
digits in the top line and four digits in the next line.
Dial a Number
1. Rotate and fully extend the satellite antenna
if you are in satellite mode. See "Holding the
Phone" on page 44.
2. Enter the number using the digit keys. As
you begin entering digits, you will see
When you are in satellite mode, you must
enter the phone number in international
format:
[ international access code ,
[ country code or Iridium code ]
[ phone number ]
Note: If you are calling another Iridium
satellite subscriber, use the Iridium code
instead of the country code.
O
3. Press
the number you dialed.
You will see either the flashing message
Calling
or the flashing messages
Registering...
series of setup tones.
If the call connects and is answered,
appears on the display for a few seconds, followed
End Call?
by .
Calling
. You will see
, and the phone will play a
Call?
00 +
, or ]
followed by
Calling
,
Connected
.