Mounting The Fan Blades - Fanimation Belleria Owner's Manual

1. Remove and discard the
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
NOTE: You will find the fan blade set packed in its own
carton and the blade holders and hardware bag in the
fan box.
2. Lay flat side of blade holder arm on a flat surface
with the inside of the blade holder arm facing
This is the side with the threaded posts and pitched
o f t o P o t i s o i n h t e b a l
the threaded posts
edge of the blade is fully seated against the blade
holder Place blade holder cover on top of the
blade,
With a Philips screwdriver, thread both screws into
tightening, position the centerline of the blade holder
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
3. Attach blade holders to the bottom of the fan motor
hub using the ¼–20
securing the blade holders to the fan
motor hub are tight and that the blade holders are
NOTE: Periodically check Blade Holder hardware and re-
secure if necessary. (see Maintenance below)
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.

Mounting the Fan Blades

motor
d e c o v r e h t e b a l d e h o d l
sure the bottom
r to final
Tighten both
CAUTION
head screws
e sure the screws with
r e i w h t
Socket-Head
Screw with Lockwasher
(2 per blade holder)
9
Figure 14
Figure 15
HARDWARE USED:
PHILLIPS HEAD
SCREWS
Figure 16
HARDWARE USED:
SOCKET HEAD
SCREWS
Blade Holder Arm
Blade Holder Cover