Advertisement
TROUBLESHOOTING
A)
Atomiser disc spins but does not spray or sprays irregularly. Check:
- the feed nozzle. If the feed nozzle is blocked remove and soak in soapy
water.
Never blow through the nozzle with your mouth.
- that the feed nozzle gives a flow rate within the operating range
- the atomiser disc is clean and undamaged. Clean or replace.
- the flow valve for blockage. Clean if necessary.
B)
Atomiser disc fails to spin or spins unevenly. Check:
- that the batteries are fitted correctly.
- the condition of the batteries. Replace if necessary.
- that electrical terminals and contact points are clean and that electrical wires
are not broken or corroded.
- the motor for corrosion or obvious signs of wear. Replace if necessary.
- the atomiser disc and atomiser cone housing are fitted correctly (see 'AFTER
SPRAYING - TO REFIT THE ATOMISER DISC').
N.B. Battery condition can be checked with a torch (or a torch light bulb and
electrical wire).
C)
Spray liquid spills from the atomiser cone during spraying:
- angle of the spray head to the ground is too great - reduce the angle.
- flow rate too high - fit feed nozzle with lower flow rate and reduce walking
speed accordingly.
HERBIFLEX-4 EXTRA
To fit the bottle to the Handle/Valve, fill the
bottle to the required level and place it on a
level surface. Fit the Handle/Valve into the
bottle ensuring that the bottle handle is in line
with the flow control valve. Tighten the bottle
securing cap and pass the air bleed tube through
the bottle handle. This is important to ensure
that the air bleed system functions correctly.
1
Press lever down (1) for treating small areas.
3
3
Press down and forward (2) for continuous
2
spraying. To stop flow, pull back lever and
2
release. N.B. for safety, valve can be locked in
off position by pushing lever forward (3)
17
Advertisement
