Advertisement
2) Remove the switch end
piece as shown on the label.
BEFORE SPRAYING FOR THE FIRST TIME
Before spraying for the first time use water and liquid detergent only to familiarise your-
self with the sprayer and check the spray pattern produced.
Put around half a litre of water in backpack or bottle and add a small amount (one to two
ml) of liquid detergent such as household washing up liquid. The detergent is important
to reduce the surface tension in the liquid feed tube and helps ensure an even flow. With
the sprayer in the spraying position, check for leaks.
above the ground or top of weed canopy with the lance at an angle of 35-40
ground. Spray on one spot for around 10 seconds, preferably on a clean dry surface e.g.
concrete where you will be able to see the spray pattern produced.
3) Insert four batteries (D-cell/R20)
negative, i.e. flat, end first.
Switch on the sprayer and then open the
flow control valve. Again check for
leaks.
When spraying, the spray head should be held 5-7 cm
6
o
to the
Advertisement
