Advertisement
STORAGE
Before storing the HERBIFLEX-4 for long periods disassemble the sprayer by re-
moving the four screws in the battery case and clean all electrical contacts with a wire
brush or similar. Reassemble and with the sprayer in the collapsed position i.e. bat-
teries removed, store in a dry place away from direct sunlight. Batteries should be
stored in a dry place away from direct sunlight.
check spring
remove batteries
clean switch
contacts
OPTIONAL EXTRAS
Spray shield
In some instances where it is essential to
minimise any spray drift a spray shield can
be used. This should only be used with the
standard atomiser cone housing A90.
To fit the spray shield, remove the head adjustment wingnut and screw. Slip the
shield over the spray head so that it sits around the top of the motor housing. Fit the
screw, washers and wingnut provided with the spray shield to secure it and set the
angle of the spray head.
Atomiser cone B120 (for wider swaths)
If wider swaths (up to 75 cm) are needed an atomiser cone housing with a wider
opening (B120) should be used. This is supplied with a set of feed nozzles (yellow,
orange and red) which give the higher flow rates needed for treating using wider
swaths. (see 'MIXING, FILLING AND CALIBRATION').
This should be fitted as described in 'AFTER SPRAYING - TO REFIT THE AT-
OMISER DISC.'
16
Advertisement
