Entering Installer Advanced Programming - Danfoss TP7001 Range Installation Manual

4.2 Entering Installer Advanced Programming

To access the Installer Advanced Programming Mode
follow the steps below:
a) Press and hold
User Advanced Programming, the display will
GB
change to look like the image opposite.
b) Press and hold
Installer Advanced Programming, the display will
change to look like the image opposite.
c) Use the + and - keys to scroll backwards and forwards
between options then the
the option settings. The fl ashing digits in the centre
of the display indicate the number of the selected
option. The large characters in the top or bottom of
the display indicate the option value selected.
d) To return to RUN, press and hold PROG until the display returns
to previous RUN mode.
Option 30 - Set Temperature Upper Limit
This allows the upper limit of the thermostat setting
range to be limited. Press + until Option 30 is
displayed, use V or Λ to select required setting.
Can be set to any value between 40.0°C and 5°C in
0.5°C steps
Factory setting = 30°C
8
V
and PROG for 3 seconds to enter
V Λ
, and PROG for 5 seconds to enter
V
and
Λ
keys to change
TP7001