Ports Descriptions; Reset Button Behavior - Patton electronics SmartNode 4520 Series User Manual

SmartNode 4520 & 4110 Series User Manual

Ports descriptions

The SmartNode 4520 Series rear panel ports are described in
Port Location
10/100 Ethernet Rear panel RJ-45 connectors (see
ETH 0/0 & ETH 0/1
Analog voice port, Rear panel FXS RJ-11(6 position, 4 wire) connectors (see
FXS
Analog voice port, Rear panel FXO RJ-11(6 position, 4 wire) connectors (see
FXO
Power Rear panel The gateway is available in a DC or AC power input version (see
Console Front
panel

Reset button behavior

For those SmartNode devices that have a Reset button on the rear panel, its behavior is as follows:
•
To restart the unit with the current startup configuration—Press for less than 1 second and release the Reset
button. The SmartNode will restart with the current startup configuration.
•
To restart the unit with factory default configuration—Press the Reset button for 5 seconds until the Power
LED starts blinking. The unit will restart with factory default configuration.
•
To restart the unit in bootloader mode (to be used only by trained SmartNode technicians)—Start with the
unit powered off. Press and hold the Reset button while applying power to the unit. Release the Reset button
when the Power LED starts blinking so the unit will enter bootloader mode.
SmartNode Series VoIP routers overview
Table 2. Rear panel ports
figure 16
Ethernet device (e.g., a cable or DSL modem, LAN hub or switch).
connect the router with an analog terminal (a telephone, for example)
FXO port. EuroPOTS support (ETSI EG201 188). FXS on-hook voltage is
48V for each FXS port.
connect the router with an analog line (FXS port). EuroPOTS support
(ETSI EG201 188).
figure 3
), labeled as follows:
•
AC version (Internal power supply): 100–240 VAC, 50/60 Hz, 200 mA
•
DC version: 12 VDC, 1.25 A
Used for service and maintenance, the Console port (see
page 15), an RS-232 RJ-45 connector, connects the router to a serial terminal
such as a PC or ASCII terminal (also called a dumb terminal).
table 2.
Description
on page 32) that connect the router to an
figure 16
figure 16
1 • General information
on page 32) that
on page 32) that
figure 4
on
14