Insert Tools, Accessories; Technical Data - Hilti PD 42 Operating Instructions Manual

NOTE
When the target plate is used and very high accuracy is required, 1.2 mm should be added to the measurement
obtained.
2.13 PDA 71 measuring extension
The measuring extension is made from aluminium and is equipped with a non conductive plastic grip. The
screw on the measuring extension should be screwed into the threaded bush on the rear contact surface of
en
the PD 42. When the measuring extension is screwed onto the tool, the rear reference is then relocated to the
tip of the measuring extension, i.e. the rear reference is extended by 1270 mm (50 inches).

3. Insert tools, accessories

Target plate
Target plate
Target plate
Measuring extension
Hand strap
Soft pouch
Laser visibility glasses

4. Technical data

Right of technical changes reserved.
Technical data
Power supply
Battery condition check
Measuring range
Typical measuring range without target plate
Accuracy
Smallest unit displayed
Beam diameter
Basic operating modes
Display
30
PDA 50
PDA 51
PDA 52
PDA 71
PDA 60
PDA 65
PUA 60
Values
3V DC AA size batteries
Battery condition indicator with 4 segments showing
100%, 75%, 50%, 25% charge : No segments
shown: The batteries are exhausted
0.05...200 m
Drywall panel, white: 100 m
Concrete, dry: 70 m
Brick, dry: 50 m
Typically ±1.0 mm for single and continuous
measurement
1 mm
Beam length 10 m: Max. 6 mm
Beam length 50 m: Max. 30 mm
Beam length 100 m: Max. 60 mm
Single measuring, continuous measuring, calcula-
tion/functions
Illuminated dot matrix display with permanent
indication of operating mode and battery condition