Pro-Form 405 fit ble User Manual page 11

,
IMPORTANT: To avoid damaging the Pulse
Crossbar (97), do not use power tools and do
not overtighten the #10 x 3/4" Screws (7).
Orient the Pulse Crossbar (97) as shown.
Attach the Pulse Crossbar to the Left and Right
Handrails (69, 81) with four #10 x 3/4" Screws
(7) and four #10 Star Washers (83); start all
four Screws, and then tighten them.
Firmly tighten the two 3/8" x 2 3/4" Screws (1)
and the two 5/16" x 3/4" Screws (4).
97
7
,
With the help of a second person, hold the con-
sole assembly near the Right Handrail (81) (only
one side is shown).
Insert the Upright Wire (71) through the three
looped Wire Ties (75) under the console
assembly.
Next, connect the ground wire from the console
assembly to the Console Ground Wire (80) on
the Pulse Crossbar (97).
See the inset drawing. Connect the Upright
Wire (71) to the console wire. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Console
Assembly_
75 /
71
75
97
Wire
Ground
Wire
80--_,
Console
Wire
11