Carrier A07049 Installation Instructions Manual page 6

dedicated sensor wires m ay beused f oritsconnection. Details are provided in
sensor instructions.
Remote I ndoorTemperature Sensor
Aremote temperature sensor may beused w iththe programmable heat pump
and programmable airconditioner thermostats where i tisdesirable toinstall the
thermostat inalimited a ccess location while measuring the temperature inthe
living space. The remote room sensor may beused a s astand a lone o raverage
with local sensor.
Two-Piece T hermostat
Configuration
The Performance Series AC/HP Control can be installed in one of two
configurations. The control may be installed as a single-piece thermostat or it
may be split into two pieces and mounted in separate locations. As a single-piece
unit, all required wiring must be brought to the Equipment Control Module for
connection to the terminal strip. In two-piece configuration, the Display Module
can be mounted in the living space while the Equipment Control Module may be
mounted near the indoor furnace or fan coil. Connection from the display to the
Equipment Control Module requires only two wires. All other control wires are
connected to the Equipment Control Module from the HVAC equipment. This
configuration results in a slimmer display and locates the Equipment Control
Module containing the switching relays away from the main living space where
relay clicking will not be heard.
The model numbers on the Display Module and the Equipment Control Module
(ECM) must match or unpredictable results may occur.
Two-wire pigtail replacement part number is TX-2WR-05.