Preparing The Installation Location; Preparing The Heater Unit - Webasto Thermo Top E Installation Instructions Manual

1 2
1
2
1
1
3
Audi A4 1.9 + 2.0 TDI

Preparing the Installation Location

3
Remove the original vehicle bolt at position 1
and 3 (will be used here again). Drill hole at
position 2.
2 Ø 9.1mm bore hole, insert rivet nut
10
2 Servo hose
1 Rubberised tube clamp, plastic nut on
existing stay bolt
11

Preparing the Heater Unit

Remove the enclosed bracket for the
mounting, this will be replaced with the
2
fastening strap.
Bend the fastening strap 1 to 90° according to
the template and loosely pre-assemble.
2 M6x20 bolt, flanged nut
12
Insert two washers between the heater unit
and the bracket 3 in position 2.
Ejot screw bolts tightening torque 10 Nm!
1 Ejot screw bolt [2x]
2 Ejot screw bolt, washer [2x]
1
2
13
Inserting
rivet nut
Tie back
servo hose
Loosely
fitting the
fastening
strap on
the bracket
Assem-
bling the
bracket
9