Suzuki GSX-S1000 Owner's Manual page 29

TRIP METERS
The two trip meters are resettable
odometers. They can register two
kinds of distances at the same time.
For instance, trip meter A can register
the trip distance and trip meter B can
register the distance between fuel
stops.
To reset a meter to zero, press and
hold the ADJ button 7 or MODE
switch (Up) for 2 seconds while the
display indicates the trip meter A or B,
you want to reset. When you reset the
trip meter A or B, the fuel economy
meter will also be reset.
NOTE: When the trip meter exceeds
9999.9, the trip meter will return to 0.0
and start counting again.
INSTRUMENT PANEL LIGHT
BRIGHTNESS
Set the meter to instrument panel
light brightness, then press and hold
the ADJ button 7 or MODE switch
(Up) for 2 seconds until the "
indicators blink. Pushing the SEL but-
ton 1 or MODE switch (Up) will
change the instrument panel light
brightness in 6 steps. The brightness
indicator indicates brightness from

" " (min) to "
Push the ADJ button 7 or MODE
switch (Down) to return to instrument
panel light brightness mode.
NOTE: If the traction control system
select switch is pressed (selection of
traction mode) during instrument
panel light brightness adjustment
(while blinking), the instrument panel
light brightness cannot be adjusted or
confirmed with the handlebar MODE
switch. In this case, use the SEL/ADJ
button to adjust/confirm the instru-
ment panel light brightness or press
the traction control system select
switch again (cancellation of traction
mode selection) so that the instru-
ment panel light brightness can be
adjusted and confirmed with the han-
dlebar MODE switch.
 WARNING
Changing the display while riding
can be hazardous. Removing a
hand from the handlebars can
reduce your ability to control the
motorcycle.
Never change the display while
riding. Keep both hands on the
handlebars.
2-17

" mark

" (max).