Epson TM-C7500 Series Technical Reference Manual page 27

LED
POWER SAVING
● ●
- - -
* * * *
PRINTING
▼ ●
- - -
* * * *
WORKING
▼ ●
- - -
* * * *
PAUSE
● ●
- - -
* * * *
MENU
● ✓
- - -
* * * *
CANCELING JOB
● ●
- - -
* * * *
PRINTING-NOZZLE
● CHECK DISABLED
●
- - -
* * * *
NOZZLE CLOGGED
●
●
- - -
* * * *
NOZZLE CLOGGED
CHECK THE PRINT
●
● ●
- -
PRESS PAUSE
TO CONTINUE
LCD Printer Status
Idling (with power
saving)
*
Printing
*
After printing is done,
the printer moves to
*
idling
Pause
*
Menu
*
Canceling the jobs
*
Nozzle Verification
Technology is
disable(*)
*
Unrecoverable nozzle
dropouts happen (*)
*
Nozzle clogged (*)
Chapter 1 Product Overview
Description
If the product does not operate for
30 minutes or more while the power
is ON, it moves to the power saving
mode.
A beep sounds when printing is
done.
When the Pause button is pushed
during printing, the printer
becomes this status.
It is possible to go to the setting
mode from this state.
When the Menu button is pushed,
the printer becomes this status.
When the Cancel button is pushed
during printing, print jobs are
canceled, printing is interrupted
and print data inside the printer
are deleted.
When dot dropouts cannot be
detected due to low
environmental temperature, the
LCD display shows a message.
Printing continues.
This display is shown when
unrecoverable nozzle dropouts
happen. Printing continues.
Printing is paused temporarily, since
nozzle dropouts happened during
printing. Printing restarts when the
Pause button is pushed. When
canceling printing, push and hold
the CANCEL button for two
seconds or more before pushing
the Pause button.
button and button switch
the LCD display.
1
27