Fuel Connection - Webasto Thermo Top E Installation Instructions Manual

Fuel Connection

CAUTION!
Open the vehicle's tank-cap lock, ventilate the tank and then re-close the tank lock.
Catch any fuel running off with an appropriate container.
Install fuel line and metering pump cable harness so that they are protected against stone impact.
Unless specified otherwise, always fasten using cable clips.
Fit the fuel line and cable harness with edge protectors around sharp edges.
WARNING!
The fuel line and cable harness to the metering pump should be installed based on the cable harness
installation diagram.
1
3
1 2
37
1
38
3
4
39
1 Mecanyl fuel line
2 Ø 10mm hose clamps [2x]
3 Hose section
2
2
Assemble the silent block 1 according to the
illustration.
1 Silent block, original vehicle hole, body
washer, M6 flanged nut
Note the installation position of the metering
pump, see the Installation Instructions.
Fuel line from the heater unit on the pressure
side of the metering pump [side with
connector].
1 Metering pump cable harness
2 Fuel line from the heater unit
3 Hose section, Ø 10 mm hose clamps [2x]
4 Metering pump; rubberized tube clamp;
flanged nut
VW Fox
Connec-
ting to the
heater unit
Metering
pump
installation
location
Metering
pump
installation
location
19
i