JUKI lbh-1790 series Engineer's Manual page 82

No.
Knife solenoid lifting time setting
K13
Knife cylinder lowering time (Optional)
K14
Y-feed motor origin compensation
K15
Needle-rocking motor origin compensation
K16
Presser lifter motor origin compensation
K17
Pattern selection function under sewing mode
K18
Ineffective/effective
Ineffective
Thread trimming on the way in continuous stitching
K19
Permitted/Prohibited
Permitted
Cloth cutting knife return power
K20
This item sets output power at the time of returning
the cloth cutting knife.
0 : Min. power / 3 : Max. power
Release amount of bobbin thread trimmer
K21
at the start of sewing
This item sets the amount of releasing the bobbin
thread trimmer at the statrt of sewing.
Needle thread trimming adjustment mode
K51
start
Needle thread trimming adjustment motion starts with
READY key ON.
Bobbin thread trimming adjustment mode
K52
start
Bobbin thread trimming adjustment motion starts with
READY key ON.
Sensor check mode start
K53
*
Sensor check starts with READY key ON.
* When READY key
Item
Effective
Prohibited
is pressed at K53 , the screen below is displayed.
Setting range
5 to 100
5 to 300
-120 to 400
-10 to 10
-100 to 10
–
–
0 to 3
0 to 15
–
–
–
1 Pedal volume
2 Pedal sensor
3 Thread breakage detection
4 Cloth cutting knife sensor
5 Head tilt sensor
6 STOP switch
7 Needle rocking sensor
8 Machine woodruff plate sensor
77
− −
Edit unit Initial value
5ms 15
5ms 50
1 pulse 0
(0.025mm)
1 pulse 0
(0.05mm)
1 pulse 0
(0.05mm)
– Ineffective
– Permitted
1 0
1 pulse 8
– –
– –
– –