Various Data List; Sewing Data List - JUKI lbh-1790 series Engineer's Manual

8. VARIOUS DATA LIST

(1) Sewing data list

Sewing data are those that can be inputted to 99 patterns from pattern 1 to 99 and can be inputted to each pattern.
The sewing machine has been set in the state that the data which is necessary to set "With/without edit" cannot be
selected at the time of your purchase. Change over the function to "With edit" if necessary for the use. / Refer to
12. Method of setting sewing data with/without edit (Instruction Manual).
No.
Sewing shape
S01
This item selects the shape from among the sewing shapes of 30
different kinds which the sewing machine has.
–
* Only 12 kinds of standard sewing shapes can be selected at the
time of your purchase. When increasing the kinds of shapes,
perform setting of K04 Sewing shape selection level$ of memory
switch data. / Refer to 8.-(2) Memory switch list.
Cloth cut length
S02
This item sets the length of cloth that is cut by cloth
cutting knife. However, in case of bar-tack shape (Nos.
27, 28, 29, and 30 of S01), sewing length is set.
By making effective U19 Function of plural motions of cloth
cutting knife of memory switch data, make the plural motions of
knife by the knife size set in the item U18 Cloth cutting knife
size, and the sewing product is cut. / Refer to 8.-(2) Memory
switch list.
Knife groove width, right
S03
This item sets the clearance between cloth cutting
knife and right parallel section.
Knife groove width , left
S04
This item sets the clearance between cloth cutting
knife and left parallel section.
Overedging width, left
S05
This item sets the overedging width of left parallel
section.
Ratio of right and left shapes
S06
This item sets enlargement/reduction ratio of right side
shape making the knife position as the center.
Pitch at parallel section
S07
This item sets sewing pitch of left and right parallel
sections.
2nd bar-tacking length
S08
This item sets length of bar-tacking on the front side.
Bottom Bottom of
of square straight bar-
type tacking
1st bar-tacking length
S09
This item sets length of bar-tacking on the rear side.
Top of square
type
* 1 : Displayed according to the shape
* 2 : Displayed when it is set to with edit. Refer to 12. Method of setting sewing data with/without edit (Instruction
Manual).
* 3 : Displayed when the function is selected.
Item
Refer to 2. Standard sewing
shape list.
Bottom of
flow
68
−
Setting range
1 to 30
(30 shapes)
3.0 to 120.0
-2.00 to 2.00
-2.00 to 2.00
0.10 to 5.00
50 to 150
0.200 to 2.500
0.2 to 5.0
0.2 to 5.0
−
Edit unit Remarks
1 –
0.1mm –
0.05mm –
0.05mm –
0.05mm –
1% –
0.025mm –
0.1mm –
0.1mm –