Mounting Instructions; Troubleshooting - Klauke EK 425-L Instruction Manual

Instruction Manual
EK 425-L
Attention
During the operation of electric engines sparks can occur which might ignite highly infl ammable or explosi-
ve liquids and materials
Attention
Electric-hydraulic crimping tools should not be operated in pouring rain or under water.

4.3 Mounting instructions

Please read the assembly instructions in our general catalogue.
Attention
Even if the code number is identical only those dies should be used which are suitable for the material.
4.4 Service and maintenance instruction
Within the determined use of the tool only the dies are permitted to be changed by the customers.
Attention
Do not damage the seals of the tool. If the seals are damaged the warranty is invalidated.
5.

Troubleshooting

a.) Constant fl ashing/indicating of the red LED (pic 1.3) or the occurence of an acoustical warning signal.
see table 1. If the failure can not be solved return the tool to the nearest service center (ASC).
b.) The tool loses oil.
Return the unit to the manufacturer. Do not open it and damage the seal of the tool.
c.) The red LED fl ashes 3x and simultaneously 3 acoustic warning signals occure (see table 1).
Serious fault! If this fault occures repeatedly return the unit to an Autorized Service Center (ASC). Do not open it
and damage the seal of the tool.
In case of a one time occurence the connector has to be crimped a second time.
HE.13656_A © 01/2010 HE.13439_A © 09/2009 6
GB